Find Top Locksmith Near You

How To Open A Trunk Without A Key From The Outside?

Car Trunk Being Opened By The Correct Keys

Imagine after a long vacation, you have arrived at your residence and parked your car, and while opening the car trunk, you find that you have locked the keys inside the car? At some point in your life, you’ve encountered something like this. However, the best way to deal with this problem is not to worry about the trunk lock.

You can call a professional locksmith service to get rid of this problem. They will get you all covered from the trunk safety release lever and trunk release to the trunk release button. This post will focus on how you can open a trunk lock of your vehicle without a key from outside.

An Insight Into Locking Mechanism Of Car Trunk

Car Trunk Being Opened By The Correct Keys

The objective of a car lock is not to be challenging to operate but rather to keep your goods from tumbling out of the vehicle. Locks are becoming increasingly complex in design compared to earlier times. Code locks, dial locks, and so on. Older trucks generally have locks that require a key from the window trim.’

A flat screwdriver can unlock your trunk if you lose or misplace your car key, which is located in the storage area. As previously said, this is because they are not extremely difficult. Try turning the lock while keeping the screwdriver in the keyhole at an oblique angle, and see if it helps. Attempt to keep the trunk open after the coil has been rotated to a 90-degree angle with the lock rod. The lock will open using the key.

Locking methods on trunks were simpler then than they are now. This results in the parallel operation of two pins. When the lock is closed, the pins rotate in the other direction. The movement of the pins within the wave is caused by the movement of the key within the lock. Pop! The lock will unlock when the staples come into contact with one another. Using a screwdriver alone to rotate the lock is challenging since it demands a precise angle.

Always Safeguard Your Car Keys

Unlocking The Trunk Lock Without Car Keys

 The first and most crucial step is to focus on prevention to get started. If you’re about to lock up your car, be sure your keys are in the ignition before locking the doors because it is always better to avoid a problem than address it.

While it’s understandable if you forget to check your keys and find out that they are in the car, you should try to remain calm and follow the steps indicated below to reclaim your keys.

Initialization Step For Accessing The Lock Mechanism

Start with this tip if your car scars doors are locked, and you need to get to the trunk. Look for the manual guide if you don’t feel comfortable opening the car yourself and don’t trust any of the internet’s solutions to unlock your vehicle.

 If you’re still unsure about your capacity to open the door on your own, you might want to consider asking someone for help. A professional locksmith can help you, and he can expertly open the car door. A car scars trunk can also be spread by removing the bolts that hold the back seats in a slim jim place. Slide the seat forward to have adequate space to work in the front seat.

Removal Of Seats

 Remove the car’s back seat to reveal the bolts on the underside of the seats in case you are using modern cars. Afterward, put the seats back in place. By using a wrench, you can remove the seat bottoms and the backs of the chairs.

 After removing the backs and bottoms of the seats, you will be able to access the trunk with ease with a spare key. Once you’ve snuck inside the trunk with a flat-head screwdriver, you’ll want to look for a horizontal piece of the metal bar near the trunk’s lock. The box on the bar can be accessed by opening the bar with a flat-head screwdriver. It would help if you now turned it counterclockwise to open it.

 The trunk of your car has now been opened without the aid of a certified professional. Each seat and insulation should be positioned in their proper spots.

 Removal Of The Cylinder Lock From the Door

The final piece of advice is if you need to get into your car quickly and your trunk is locked. Once you remove the cylinder lock from the door, you can open the box. To accomplish the stage, you will need to be extremely careful and pay great attention to setting the lock. It’s best to remove the plug from the driver’s door on the B-column and is level with the door handle. Look to locate the pin by opening the door and searching.

 The thing has a hole in it after removing the plastic plug. If you look into it closely, a screw has already been put in the hole. Now that you’ve got a screwdriver, you can remove the door’s screw. If you don’t want to risk damaging your car scars paint, you need to take extra care, or you can cover it with tape. Gently pull the handle back to get closer to the key cylinder.

The Final step

 Attempt to remove the cylinder and be patient while doing so carefully. Take your time; the cylinders are packed tightly in the pocket, so this will take some effort. Don’tDon’t be hasty. There are two places where you will observe a plus sign-shaped depressurization: in the cylinder and its pocket.

 Using a flat-tip screwdriver, place it into the plus-shaped depression in the pocket of the trunk, and then crank the screwdriver until the trunk opens. To get your keys and unlock the trunk, you must now return all items to their original locations.

Operating With The Trunk Safety Release Lever

If you have a car model with a trunk release lever or a trunk button near the driver’s seat, you may be able to unlock the trunk with this method. If you’re traveling and accidentally lock yourself out of the trunk because you can’t find your key, keep this tip in mind.

 Now, you have to remove the rubber hole. A tool that allows you to hit the spot in such a way as to cause the trunk release lever, which is placed near the driver’s seat, to rise is needed. Remove the rubber plug from any holes you find in the car scars floor panel. Identifying an instrument to use if you discover a rip in the car scars floor panel necessitates searching for a suitable device. 

If you hit it, your trunk will automatically open, saving you the trouble of carrying around a set of keys. To reinstall the rubber plug, you must first remove the trunk’s lid.

 Most modern vehicles have this type of hole in the floor panel. To get to the lever, you’ll have to look for it in the hole in the floor panel.

If you are in a situation where you cannot obtain any other form of assistance, this piece of advice is worth a try. You’ll need a flat-point screwdriver to get the job done. You can open the trunk by inserting a screwdriver into its locking mechanism and turning it in either direction.

Take your time and be careful with the screwdriver. This method can damage your trunk or break the lock on it, so it isn’t beneficial.

 The Operation Trunk Release Button

This vehicle has a trunk release button that can be used in the event of an accident. This technology is now included as standard equipment on all new automobiles. Your glove box is usually to the left of your steering wheel, and you’ll find it there in most cases.

The trunk release button may not be there when you arrive; if this is the case, look in all other conceivable locations. Some vehicle’s trunk-opening buttons are located in the center console center because the button is located on the right side of the steering wheel in some models or because a lever under the driver’s seat can be used in some models instead of the trunk-opening button.

The driver must first start the engine in some vehicles before activating the trunk-opening button. Once the trunk release button is removed with a screwdriver, the two wires that run back from the button may be seen. Rip a long wire in half so that one end is significantly longer than the other. A new stage has been reached.

It would help if you now used your longer end to wrap it around the positive cable of your car’s battery and secure it in place. It’s possible that you’ll accidentally short something in your vehicle if you don’t use the shorter end of the wire to cut it.

Also, don’t use the shorter wire to touch any vehicle part. Ensure the trunk opens by connecting a 12-volt power cable to one side of the button that releases it. Try pressing the button on the trunk’s backside from all three sides. It’s possible to open the trunk by putting a 12-volt wire into it.

Call Locksmith Finder: The Best Locksmith Service Provider Near You

Be it a locked trunk or an apartment’s locked front door, you can always contact us at Locksmiths finder. We have been connecting the best locksmith services with the people of different areas, including Charlotte, San Diego, New York, and many more. What are you waiting for? Call us right now if you require locksmith service.